[[Image(humVera.png, align=right, width=600px)]] = Temperature and Humidity sensor (DHT11/DHT22) = == Software == You can download the Arduino sketch here:\\ http://code.mios.com/trac/mios_arduino-sensor/browser/trunk/Arduino/HumiditySensor This sensor sleeps most of the time. You can change the sleep interval by updating SLEEP_TIME define at the top of the file. == Wire things up == [[Image(dht22.jpg, align=right)]] Follow the instructions in ConnectingRadioModule to connect radio module. To connect the DHT22 sensor to the Arduino board follow these instructions:\\ Pin1. Connect VCC of the DHT22 sensor to +5V\\ Pin2. Connect Data to digital pin 3 of the Arduino board\\ Pin3. Not used.\\ Pin4. Connect to Ground\\ \\ Use also need a pull up resistor between +5V and Data. See picture below.\\ == Hardware - Purchase guide == To build this sensor you'll need one arduino + radio specified in the base kit found here:\\ http://code.mios.com/trac/mios_arduino-sensor/wiki/WikiStart#Buyingguide\\ With the following additional parts: 1x DHT22 Temperature and Humidity sensor (there also exist a cheaper humidity sensor called DHT11 that is less accurate but half the price).\\ http://www.aliexpress.com/item/1pcs-DHT22-digital-temperature-and-humidity-sensor-Temperature-and-humidity-module-AM2302-replace-SHT11-SHT15-Free/1031321543.html TOTAL SENSOR PRICE: $7,6 (arduino + radio) + $4,99 (DHT22) = '''$12,6''' [[Image(hum.jpg, width=500px)]]