[[Image(VeraMotion.png, align=right)]] = Motion Sensor = == Software == You can download the Arduino sketch here:\\ http://code.mios.com/trac/mios_arduino-sensor/browser/trunk/Arduino/MotionSensor This sensor sleeps most of the time. If interrupt on digital input occurs it wakes up and transmits change. == Wire things up == Follow the instructions in ConnectingRadioModule to connect radio module. Connect the digital OUT of the motion sensor to digital input 3 of Arduino board. Connect VCC to +5V of the Arduino board. GND to GND. Use the trimpot Sx on sensor to set sensitivity. Trimpot Tx tunes how long the sensor should be triggered (5sec min - 200sec max). == Hardware - Purchase guide == To build this sensor you'll need one arduino + radio specified in the base kit found here:\\ http://code.mios.com/trac/mios_arduino-sensor/wiki/WikiStart#Buyingguide\\ With the following additional parts: 1x Motion sensor\\ http://www.aliexpress.com/item/Freeshipping-PIR-Sensor-Human-Body-detecting-module-Pyroelectric-HC-SR501-For-Arduino-MCU/967005480.html TOTAL SENSOR PRICE: $7.6 (arduino + radio) + $1.7 (motion sensor) = '''$9.3''' [[Image(motion.jpg, width=500px)]]