= UI5 Installation and Setup for IT100 =


== IT-100 connected to Vera using an USB-to-RS232 converter ==
=== Preliminary Steps ===
Before attempting to install the plug-in, it is recommended to connect the respective RS-232 adapter, and set this up first in order to establish connectivity. To set up the serial port:
1. Open the Vera UI and navigate to '''Apps''' >> '''Develop Apps''' >> '''Serial Port Configuration'''.
2. If the serial port is not in the list, restart Luup.
3. Set the '''Baud''' to ''9600''.
4. Optionally you can rename this port in the '''Name''' input box.
5. Save.

=== Plugin Setup ===
1. First go to '''Apps''' >> '''Install Apps''' and install the plugin. 
2. After the plugin has been installed go to '''Apps''' -> '''Develop Apps''' -> '''Serial port configuration''' and select the alarm panel device from the '''Used by device''' drop-down list.
2. Save.
3. After Luup has restarted reload the UI.
[[Image(ui5_serial_port_config.png)]]

== IT-100 connected to Vera using a WIZnet or Roving Networks IP-to-Serial adapter ==
=== Plugin Setup ===
1. Open the alarm panel device control panel >> '''Advanced''' tab. In the '''ip''' input field enter the IP address of the Ethernet adapter and the port on which it is connected. (e.g. if the IP address of the Ethernet adapter is ''192.168.8.164'' and it is connected on port ''5000'', the '''ip''' value should be ''192.168.8.164:5000'')
2. Save.
3. After Luup has restarted reload the UI.
[[Image(ui5_ip_config.png)]]

= UI5 Installation and Setup for IP170/2DS =

NOTE this is currently beta only and will only work if the IP170/2DS has the correct firmware.

 * Download the plug-in from [http://code.mios.com/trac/mios_dscalarmpanel/changeset/74/branches/2ds?old_path=%2F&format=zip this ]location.
 * Install as per the above procedure and follow the creation instructions for The IT100 and WIZnet; however for the IP address the port needs to be changed to 4025 instead of 5000.
 * After the Plugin is created, open the advanced tab of the parent device and change the InterfaceType variable from IT100 to 2DS then Save.