| | 121 | = Additional Setup = |
| | 122 | |
| | 123 | * To configure the correct Partitions and Zones, select the parent device (as named during the creation process). |
| | 124 | * Click the '''Advanced''' tab |
| | 125 | * Under Partitions by default there will be '''1''' present, if additional partitions are to be set up then enter them in sequential manner separated by a comma as follows: |
| | 126 | For two partitions enter '''1,2''' |
| | 127 | For three partitions enter '''1,2,3''' etc etc... |
| | 128 | |
| | 129 | Under the different Zone fields, enter the zone numbers in the same type of sequence. By default it will display '''1,2,3,4,5,6''' in ''!DoorZones''. |
| | 130 | Note you will need to know which Zones are set up which on your panel. They may not be in sequence (per the above), and can be entered depending on their type in any of the three Zone variables. |
| | 131 | |
| | 132 | If remote Arming and Disarming is not required from Vera, then exit and save; however if this is required then stay in this screen and enter one of the following into the ''!EnableRemoteArm'' variable: |
| | 133 | |
| | 134 | * '''disarm''' (Least secure as all functions are available including disarm) |
| | 135 | * '''stay''' (This will enable stay arming and away arming, but not disarm) |
| | 136 | * '''arm''' (Will only enable away mode arming) |
| | 137 | |
| | 138 | |
| | 139 | NOTE: '''disarm''' is the least secure and enables all remote arming features. |
| | 140 | |
| | 141 | After entering any of the above, exit and save. |
| | 142 | |
| | 143 | To set the time on the panel, in the main tab of the device, enter your PIN and click "Set Time" |
| | 144 | |
