Changes between Version 5 and Version 6 of UI4

Timestamp:

2011-10-21 12:18:42 (13 years ago)

Author:

mcvflorin

Comment:

--

UI4

@@ -16 +16 @@
 4. Go to '''Create Device''':
  * In the '''!UpnpDevFilename''' field enter ''D_ElkAlarmPanel1.xml''
- * In the '''Description''' field enter ''Elk M1 Alarm Panel'' (or any name you want). 
+ * In the '''Description''' field enter ''Elk M1 Alarm Panel'' (or any name you want).
+ * If the panel is connected to Vera on the '''Ethernet''' port (using Elk M1XEP or an RS232-to-Ethernet adapter), enter the IP address and port in the '''!IpAddress''' field (e.g. 192.168.8.23:5000).
  * Optionally you can select a room from the '''Room''' drop-down list.
  * Click '''Create Device'''.
 
-'''NOTE:''' If the panel is connected to Vera on the '''Ethernet''' port (using Elk M1XEP or an RS232-to-Ethernet adapter), enter the IP address and port in the '''!IpAddress''' field (e.g. 192.168.8.23:5000).
-
-5. If the panel has been connected to Vera on a USB port, you must configure the serial port. Go to '''Serial port configuration''':
+5. If the panel has been connected to Vera on a USB port, you must configure the serial port. Go to '''Serial port configuration''':''
  * Set the '''Baud''' to ''115200''.
  * Select the alarm panel device from the '''Used by device''' drop-down list.