= UI4 Installation and Setup =

== Preliminary steps ==
=== USB RS-232 Serial Adapter ===
If the panel has been connected to Vera using an USB RS-232 Serial Adapter, first check to see if the serial port has been detected by Vera:
1. Open the Vera UI.
2. In the '''Toolbox''' section, open '''MiOS Developers''' >> '''Serial Port Configuration'''.
3. If you don't see the serial port in the list, restart Luup.
4. Configure the serial port:
 * Set the '''Baud''' to ''115200''.
 * Optionally you can give a name to this serial port in the '''Name''' field.
5. Close this window and save.

=== Elk M1XEP ===
Follow the installation and configuration procedure in the '''M1XEP Installation Manual'''.

=== !WiFi RS-232 Serial Adapter ===
Follow the installation and configuration procedure from its manual. The serial port must be configured to use a '''Baud rate''' of ''115200''.

== Plugin installation and setup ==
1. Download the plugin files on your computer.
 * [[http://code.mios.com/trac/mios_elk-alarm-panel/changeset/45/tags/1.01?old_path=%2F&format=zip|Plugin files]]
2. Go to '''MiOS Developers''' -> '''Luup Files''' and upload the files you just downloaded.
3. If ''Restart Luup after upload'' is checked, uncheck it, then click '''GO'''.
4. Go to '''Create Device''':
 * In the '''!UpnpDevFilename''' field enter ''D_ElkAlarmPanel1.xml''
 * In the '''Description''' field enter ''Elk M1 Alarm Panel'' (or any name you want).
 * If the panel is connected to Vera on the '''Ethernet''' port using the Elk M1XEP or '''wireless''' using a !WiFi RS-232 Serial Adapter, enter the IP address and port in the '''!IpAddress''' field (e.g. 192.168.8.23:5000).
 * Optionally you can select a room from the '''Room''' drop-down list.
 * Click '''Create Device'''.

5. If the panel has been connected to Vera on a USB port, go to '''Serial port configuration''' and select the alarm panel device from the '''Used by device''' drop-down list.
6. Close this window and click '''SAVE'''.
7. After Luup has restarted reload the UI.