| | 36 | Vera must learn the devices from your system. For that follow the this steps : |
| | 37 | |
| | 38 | * Put the plugin in Learn Mode by pressing on the '''Learn''' button. A message will appear in the status box at the top confirming that the plugin entered Learn Mode. |
| | 39 | |
| | 40 | [[Image(EnterLearnMode.png)]] |
| | 41 | |
| | 42 | * Press a button on a PTM switch (F6-02-xx or F6-03-xx device), or the Teach-in button on a Single Input Contact (D5-00-xx device), or the Teach-in button for temperature sensor(A5-02-xx),temperature and humidity sensor (A5-04-xx),light sensor (A5-06-xx) or occupancy sensor (A5-07-xx) devices to send a Teach-in telegram. A message should appear in the status box at the top stating that a device was found. If no message is shown, or if the "Found unknown device" message is shown, it means that the device isn't supported yet. |
| | 43 | |
| | 44 | [[Image(DeviceFound.png)]] |
| | 45 | |
| | 46 | * After you added the devices (you can add more than one device at a time), press the '''Normal''' button. The Luup engine should reload and new devices should be created (refresh your browser if new devices are not shown ). |
| | 47 | |
| | 48 | |
| | 49 | |
