== EnOcean ESP3 Gateway ==

== Overview ==

The EnOcean ESP3 Gateway plugin provides the ability to control your EnOcean devices from your system such as PTM switches, occupancy sensors, window/door sensors and temperature sensors.

== Requirements ==

* USB300C gateway 

[[Image(USB300C.png)]]

== Installation == 

Plug in the USB300C gateway into Vera's USB port.

== Configuration ==

After installing the plugin, a "EnOcean Gateway" device will be created.

[[Image(EnOceanDevice.png)]]

Assign the serial port to Enocean Gateway : go to "Apps/Develop Apps/Serial Port Configuration" and select from "Used by device" drop down list the Enocean Gateway. Also set the following: 
* '''Baud Rate''' : 5700; 
* '''Data bits''' : 8;
* '''Parity''' : none;
* '''Stop bits''' : 1.

[[Image(SerialPort.png)]]

Click on "Save" button in the right upper corner and refresh you browser.   

== Make devices known to Vera ==   

Vera must learn the devices from your system. For that follow the this steps :

* Put the plugin in Learn Mode by pressing on the '''Learn''' button. A message will appear in the status box at the top confirming that the plugin entered Learn Mode.

[[Image(EnterLearnMode.png)]]

* Press a button on a PTM switch (F6-02-xx or F6-03-xx device), or the Teach-in button on a Single Input Contact (D5-00-xx device), or the Teach-in button for temperature sensor(A5-02-xx),temperature and humidity sensor (A5-04-xx),light sensor (A5-06-xx) or occupancy sensor (A5-07-xx) devices to send a Teach-in telegram. A message should appear in the status box at the top stating that a device was found. If no message is shown, or if the "Found unknown device" message is shown, it means that the device isn't supported yet.

[[Image(DeviceFound.png)]]  

* After you added the devices (you can add more than one device at a time), press the '''Normal''' button. The Luup engine should reload and new devices should be created (refresh your browser if new devices are not shown ).