Changes between Version 8 and Version 9 of WikiStart

Timestamp:

2012-07-24 14:34:26 (12 years ago)

Author:

mcvflorin

Comment:

--

WikiStart

@@ -10 +10 @@
 
 The plugin exposes the panel zones as motion sensors, so they can be used in scenes and events.
+
+[[Image(ui4_dashboard.png)]]
+
+[[Image(ui5_dashboard.png)]]
 
 == Installation ==
@@ -27 +31 @@
 
 If the adapter has been detected by MiOS and configured, you can proceed to install the plugin.
+
+[[Image(ui5_serial_port.png)]]
 
 === UI4 ===
@@ -52 +58 @@
 || '''!ExtraFeatures''' || Setting this parameter to '''1''' allows the plugin to control some extra features. Currently ''Chime Mode'' and ''Quick Arm'' are the only extra features, but this may change in the future. This is '''0''' by default, because enabling this greatly increases the amount of data Vera must receive from the panel, which could slow Vera down. Only enable this if you use any of the extra features. Valid values: '''0''', '''1'''. ||
 
+[[Image(ui5_panel_advanced.png)]]
+
 == Usage ==
 === Basic tasks ===
@@ -60 +68 @@
 
 If ''Quick Arm'' is enabled, it's possible to arm the partition without entering the User Code. However, disarming will still require the user code.
+
+[[Image(ui5_partition_partition.png)]]
 * '''Bypass / unbypass zone'''
 1. Open the control panel of the alarm panel device, then the ''Zones'' tab. You will see the list of the detected zones in all partitions and their status.
@@ -65 +75 @@
 3. Click on the buttons to bypass/unbypass the zones.
 4. Wait several seconds (about 10 seconds to be sure) then click on the ''Zones'' tab again to refresh it.
+[[Image(ui5_panel_zones.png)]]
 * '''Enable / disable Chime Mode'''
 1. Open the control panel of the partition.