Plugin : GCE IPX800v3 roller shutter controller Version : 2.3 Auteur : FaTaL25 Website : ---- Informations (in french) : http://www.gce-electronics.com/forum/viewtopic.php?f=33&t=868 Informations: Where to buy GCE IPX800v3 - http://www.gce-electronics.com/fr/57-carte-8-relais-ethernet-ip-ipx800-v3.html The card is a ethernet relay card. It has : - 8 digital inputs - 8 relays - 4 analog inputs - 128 timers... With extensions, you can have : - 32 digital inputs - 32 relays IPX800v3 can control a roller shutter with 2 relays. 1 relay ON/OFF 1 relay UP/DOWN but it's not possible to command roller shutter to 30% for example. The plugin can do it for you. For my plugin, I use M2M (machine to machine - TCP socket) Requierments : You must have : - Vera (3 or lite) - IPX800v3 - at least a shutter connected to your IPX800v3 Limitations UI5 only - Not tested on UI4 Works only with GCE IPX800v3 with firmware over 3.05.00 Plugin installation : - Upload attached files - Restart LUUP engine - create device : "Apps > Develop Apps > Create device" Il faut remplir les champs : -- "Upnp Device Filename" : "D_WindowCovering1ipx.xml" -- "Upnp Implementation Filename" : "I_WindowCovering1ipx.xml" - Restart LUUP engine - New device has been created and now, you have to configure it. Plugin Configuration : - Go to the tab "control" - Define the cycletime of your roller shutter. Cycletime is the time in seconds the shutter moves the down position to the up position. (0% to 100%) - Define GCE IPX800v3 IP adress - Define GCE IPX800v3 Port M2M (machine to machine) (default 9870) - Define the ON/OFF relay number (1 to 32) - Define the UP/DOWN relay number (1 to 32) - Restart LUUP engine It's done. Now, assuming that you have a push button connected to your IPX (which is not necessarily required for the plugin but it is more convenient for local orders), you must configure your IPX it sends a command the Vera whenever you press the PB. To do this, go here: http:///protect/settings/push1.htm Select the entry for your BP wired (for example 5) Then enter in the server field the IP of your VERA. Port: 3480 Enable push ticked then SAVE In Push1: /data_request?id=lu_action&DeviceNum=&serviceId=urn:upnp-org:serviceId:WindowCoveringipx1&action=BP_IPX replace the ID number of the module created earlier in the Vera. (wrench / Advanced / ID field) For initialising the plugin, make an OPEN or CLOSED command and wait 2 cycletimes. Now, you can use your roller shutter like a Fibaro FGR221 :)