| | 1 | = Installation = |
| | 2 | 1. Download the following files from Source Control: |
| | 3 | * export:trunk/I_SQBlaster1.xml |
| | 4 | * export:trunk/D_SQBlaster1.xml |
| | 5 | * export:trunk/D_SQBlaster1.json |
| | 6 | 1. Goto ''MiOS developers'' --> ''Luup files'' |
| | 7 | 1. Click the '''(Browse)''' buttons on the bottom, and enter the 3 filenames references above. |
| | 8 | 1. Select the checkbox "''[x] Restart Luup after upload''" and click '''(Go)''' |
| | 9 | 1. ... wait whilst it uploads and restarts the Lua engine ... |
| | 10 | 1. If successful, you'll see the 3x files listed in the System (using the exact names listed above). |
| | 11 | 1. Navigate to the ''Create device'' tab |
| | 12 | 1. For the ''!UpnpDevFilename'' field, type "`D_SQBlaster1.xml`". |
| | 13 | 1. For the ''Description'' field, type "IR Blaster - Room". |
| | 14 | 1. Click '''(Create device)''' button |
| | 15 | 1. Close this Dialog and click '''(Save)''' |
| | 16 | 1. At this point you are readying to attach the IP Address of the SQBlaster. |
| | 17 | 1. Open the Spanner/Wrench on your new "IR Blaster - Room" device. |
| | 18 | 1. Select the '''[Advanced]''' Tab |
| | 19 | 1. Enter a value for the ''ip'' field to match the address of your Network attached SQBlaster Device. In the example, I'm connecting to 192.168.5.45. This will be different for your installation. |
| | 20 | 1. Dismiss this Dialog and Press '''(Save)''' |
