= Installation = 1. Download the following files from Source Control: * export:trunk/I_SQBlaster1.xml * export:trunk/D_SQBlaster1.xml * export:trunk/D_SQBlaster1.json 1. Goto ''MiOS developers'' --> ''Luup files'' 1. Click the '''(Browse)''' buttons on the bottom, and enter the 3 filenames references above. 1. Select the checkbox "''[x] Restart Luup after upload''" and click '''(Go)''' 1. ... wait whilst it uploads and restarts the Lua engine ... 1. If successful, you'll see the 3x files listed in the System (using the exact names listed above). 1. Navigate to the ''Create device'' tab 1. For the ''!UpnpDevFilename'' field, type "`D_SQBlaster1.xml`". 1. For the ''!UpnpImplFilename'' field, type "`I_SQBlaster1.xml`". 1. For the ''Description'' field, type "IR Blaster - Room". 1. Click '''(Create device)''' button 1. Close this Dialog and click '''(Save)''' 1. At this point you are readying to attach the IP Address of the SQBlaster. 1. Open the Wrench (or Spanner!) on your new "IR Blaster - Room" device. 1. Select the '''[Advanced]''' Tab 1. Enter a value for the ''ip'' field to match the address of your Network attached SQBlaster Device. In the example, I'm connecting to 192.168.5.45. This will be different for your installation. 1. Dismiss this Dialog and Press '''(Save)'''