Changes between Version 3 and Version 4 of InstallationController-UI4

Timestamp:

2011-04-11 06:00:02 (14 years ago)

Author:

guessed

Comment:

--

InstallationController-UI4

@@ -1 +1 @@
 = Installation =
-
+[[Image(SQBlasterControllerFiles.png, align=right, 30%)]]
 == Install the SQController Plugin Code ==
  1. Download the following files from Source Control, and expand it to give the files listed below
@@ -17 +17 @@
  1. If successful, you'll see the 7 filenames listed in the System (using the exact names listed above).
 
+[[Image(SQBlasterControllerDeviceCreation.png, align=right, 30%)]]
 == Create the SQController Device ==
  1. Navigate to the ''MiOS developers'' --> ''Create device'' tab
@@ -25 +26 @@
  1. Close this Dialog and click '''(Save)'''
 
+[[BR]]
+[[BR]]
+
+[[Image(SQRemoteFiles.png, align=right, 30%)]]
 == Extract Configuration Files from SQRemote ==
  1. Backup your SQRemote configuration to Box.net
@@ -38 +43 @@
  1. If successful, you'll see the filenames listed in the System (using the exact names extracted above).
 
+[[Image(SQBlasterControllerIPAddressConfig.png, align=right, 30%)]]
 == Configure the SQBlaster IP Addresses ==
 The setup above creates SQBlaster devices, one for each registered with SQRemote.  These need to be configured with IP Addresses before they can function.
@@ -43 +49 @@
  1. Open the Wrench (or Spanner!) on your new "''SQBlaster sq-blaster-xxxx.local''" device.
  1. Select the '''[Advanced]''' Tab
- 1. Enter a value for the ''ip'' field to match the address of your Network attached SQBlaster Device.  In the example, I'm connecting to `192.168.5.45`.  This will be different for your installation.
+ 1. Enter a value for the ''ip'' field to match the address of your Network attached SQBlaster Device.  In the example, I'm connecting to `192.168.5.101`.  This will be different for your installation.
  1. Dismiss this Dialog and Press '''(Save)'''