Changes between Version 33 and Version 34 of WikiStart

Timestamp:

2015-02-16 02:07:55 (9 years ago)

Author:

pmnb

Comment:

--

WikiStart

@@ -27 +27 @@
 7. Click the "Pair" button on the TCP Lighting config UI. Wait a few seconds.  If the pairing is successful, the plugin will then poll the gateway and create child devices for each bulb.  If a bulb's room name matches that of a Vera room, it will be automatically added to the room. 
 
-__Installation (Manual Version 2.0 Installation/UI5)__
+__Manual Installation of Version 2.0 (UI5)__
 
 '''Note:''' Only use this version if your Connected By TCP gateway is running firmware version 3.0.74 or later.
 
-1. Download the [http://code.mios.com/trac/mios_tcplighting/raw-attachment/wiki/WikiStart/TCPLighting%20Plugin%20v1.0.1.zip TCPLighting Plugin 2.0] zip file attached below.
+1. Download the [http://code.mios.com/trac/mios_tcplighting/raw-attachment/wiki/WikiStart/TCPLighting%20Plugin%20v2.0.zip TCPLighting Plugin 2.0] zip file attached below.
 
 2. Upload all of the plugin XML, JSON and LUA files using the ''Apps / Develop Apps / Luup files'' page. Make sure to click the "Restart Luup after upload" checkbox
@@ -46 +46 @@
 
 8. Click the "Pair" button on the TCP Lighting config UI. Wait a few seconds.  If the pairing is successful, the plugin will then poll the gateway and create child devices for each bulb.  If a bulb's room name matches that of a Vera room, it will be automatically added to the room. 
+
+__Manual Installation of Version 1.0.1 (UI5)__
+
+'''Note:''' Only use this version if your Connected By TCP gateway is running a firmware version ''prior to'' 3.0.74.
+
+1. Download the [http://code.mios.com/trac/mios_tcplighting/raw-attachment/wiki/WikiStart/TCPLighting%20Plugin%20v1.0.1.zip TCPLighting Plugin 1.0.1] zip file attached below.
+
+2. Upload all of the plugin XML, JSON and LUA files using the ''Apps / Develop Apps / Luup files'' page. Make sure to click the "Restart Luup after upload" checkbox
+
+3. Wait for the Luup restart to complete.
+
+4. If you are lucky, the auto-discovery feature will have detected the ''Connected By TCP'' gateway and configured its IP address.   
+
+5. If the auto-discovery failed, you will see the message ''No gateway IP address specified, autodiscovery failed'' in the gateway device UI.  Some of the reasons why this might happen, and how to manually configure the gateway IP address, are outlined in the Auto-Discovery section below.
 
 __Auto-Discovery__