= Motion Sensor Plugin for the !VistaCam =

This plugin adds support for the !VistaCam motion detection, creating a motion sensor that is tripped when the !VistaCam sends a 'motion detected' notification.

== UI Compatibility ==

This plugin is compatible with both UI4 and UI5.

== Installation ==

=== UI4 ===

1. Download this file: [http://code.mios.com/svn/mios_vistacam/tags/1.0/I_VistaCamMS.xml I_VistaCamMS.xml]
2. Upload the file on Vera:
 1. On the Vera UI, in the ''Toolbox'' section, open ''MiOS Developers'' >> ''Luup Files''.
 2. Upload the file.
 3. Uncheck ''Restart Luup after upload''.
 4. Click ''GO''.
3. Set the camera to use that file as the implementation file:
 1. On the Vera UI open the camera's control panel (click on the wrench).
 2. On the ''Advanced'' tab, in the '''impl_file''' file field enter ''I_VistaCamMS.xml''
 3. Close the control panel.
4. Save.

=== UI5 ===

1. Install the !VistaCam Motion Detection plugin.
2. Set the camera to use that file as the implementation file:
 1. On the Vera UI open the camera's control panel (click on the wrench).
 2. On the ''Advanced'' tab, in the '''impl_file''' file field enter ''I_VistaCamMS.xml''
 3. Close the control panel.
3. Save.

== Troubleshooting ==

* ERROR: Missing camera IP address.
SOLUTION: Enter the correct camera IP address and port (or the camera's URL if it's not in the same network as Vera, in the '''ip''' field in the camera's ''Advanced'' tab. (e.g. 192.168.81.24:8080)

* ERROR: Missing MiOS unit IP address.
SOLUTION: Enter the Vera IP address and port (or the URL if it's not in the same network as the camera) in the '''MiosUnitAddress''' field in the camera's ''Advanced'' tab.

* ERROR: Failed to configure the camera.
SOLUTION: This error can occur for several reasons:
 1. The camera's IP address and port (or URL) is not correct.
 2. The camera's username and/or password are not correct.
 3. The camera's username and password are not of an admin account. '''The plugin requires and admin account to configure the camera.'''