Last modified 8 years ago Last modified on 2011-10-14 04:35:39

Installation

ECM-1240 Configuration

The ECM-1240's come with a few [Windows based] Tools that let you reconfigure them. It is beyond the scope of this document to cover their full featureset, but there are a few "values" that must be set correctly in order for the Plugin to work.

The following screenshots, courtesy of @smilligan, show some of the main settings in both the EtherX tool, as well as the ECM-IA Tool.

Note: After you switch to HTTP mode, you must reboot the ECM-1240 before you can set the POST URL. After setting the POST URL, perform another reboot and you are ready to go.

Sensitive data has been redacted, Key settings are highlighted in Green boxes.

References

  • Need to reboot ECM-1240 device twice for Protocol changes to stick @ChrisAZ

Attachments