Changes between Version 9 and Version 10 of UI4

Timestamp:

2011-10-26 14:22:58 (13 years ago)

Author:

mcvflorin

Comment:

--

UI4

@@ -1 +1 @@
 = UI4 Installation and Setup =
 
+== Preliminary steps ==
+=== USB RS-232 Serial Adapter ===
+If the panel has been connected to Vera using an USB RS-232 Serial Adapter, first check to see if the serial port has been detected by Vera:
+1. Open the Vera UI.
+2. In the '''Toolbox''' section, open '''MiOS Developers''' >> '''Serial Port Configuration'''.
+3. If you don't see the serial port in the list, restart Luup.
+4. Configure the serial port:
+ * Set the '''Baud''' to ''115200''.
+ * Optionally you can give a name to this serial port in the '''Name''' field.
+5. Close this window and save.
+
+=== Elk M1-XEP ===
+Follow the installation and configuration procedure in the '''M1-XEP Installation Manual'''.
+
+=== WiFi RS-232 Serial Adapter ===
+Follow the installation and configuration procedure from its manual. The serial port must be configured to use a '''Baud rate''' of ''115200''.
+
+== Plugin installation and setup ==
 1. Download these files on your computer:
 * [[http://code.mios.com/svn_public/mios_elk-alarm-panel/D_ElkAlarmPanel1.json|D_ElkAlarmPanel1.json]]
@@ -19 +37 @@
  * Click '''Create Device'''.
 
-5. If the panel has been connected to Vera on a USB port, you must configure the serial port. Go to '''Serial port configuration''':''
- * Set the '''Baud''' to ''115200''.
- * Select the alarm panel device from the '''Used by device''' drop-down list.
- * Optionally you can give a name to this serial port in the '''Name''' field.
+5. If the panel has been connected to Vera on a USB port, go to '''Serial port configuration''' and select the alarm panel device from the '''Used by device''' drop-down list.
 6. Close this window and click '''SAVE'''.
 7. After Luup has restarted reload the UI.