Version 10 (modified by mcvflorin, 13 years ago) (diff)

--

UI4 Installation and Setup

Preliminary steps

USB RS-232 Serial Adapter

If the panel has been connected to Vera using an USB RS-232 Serial Adapter, first check to see if the serial port has been detected by Vera:

  1. Open the Vera UI.
  2. In the Toolbox section, open MiOS Developers >> Serial Port Configuration.
  3. If you don't see the serial port in the list, restart Luup.
  4. Configure the serial port:
    • Set the Baud to 115200.
    • Optionally you can give a name to this serial port in the Name field.
  5. Close this window and save.

Elk M1-XEP

Follow the installation and configuration procedure in the M1-XEP Installation Manual.

Wi Fi? RS-232 Serial Adapter

Follow the installation and configuration procedure from its manual. The serial port must be configured to use a Baud rate of 115200.

Plugin installation and setup

  1. Download these files on your computer:
  1. Go to MiOS Developers -> Luup Files and upload the files you just downloaded.
  2. If Restart Luup after upload is checked, uncheck it, then click GO.
  3. Go to Create Device:
    • In the UpnpDevFilename field enter D_ElkAlarmPanel1.xml
    • In the Description field enter Elk M1 Alarm Panel (or any name you want).
    • If the panel is connected to Vera on the Ethernet port (using Elk M1XEP or an RS232-to-Ethernet adapter), enter the IP address and port in the IpAddress field (e.g. 192.168.8.23:5000).
    • Optionally you can select a room from the Room drop-down list.
    • Click Create Device.
  1. If the panel has been connected to Vera on a USB port, go to Serial port configuration and select the alarm panel device from the Used by device drop-down list.
  2. Close this window and click SAVE.
  3. After Luup has restarted reload the UI.
  4. Enjoy using the plugin. :)

Attachments