Elk M1 Alarm Panels Plugin

Installation & Setup

1. Download these files on your computer:

• ​D_ElkAlarmPanel1.json
• ​D_ElkAlarmPanel1.xml
• ​D_ElkAlarmPartition1.json
• ​D_ElkAlarmPartition1.xml
• ​I_ElkAlarmPanel1.lua
• ​I_ElkAlarmPanel1.xml
• ​S_AlarmPartition2.xml
• ​S_ElkAlarmPanel1.xml

2. Go to MiOS Developers -> Luup Files and upload the files you just downloaded.
3. If Restart Luup after upload is checked, uncheck it, then click GO.
4. Go to Create Device:
   • In the UpnpDevFilename field enter D_ElkAlarmPanel1.xml
   • In the Description field enter Elk M1 Alarm Panel (or any name you want).
   • If the panel is connected to Vera on the Ethernet port (using Elk M1XEP or an RS232-to-Ethernet adapter), enter the IP address and port in the IpAddress field (e.g. 192.168.8.23:5000).
   • Optionally you can select a room from the Room drop-down list.
   • Click Create Device.

5. If the panel has been connected to Vera on a USB port, you must configure the serial port. Go to Serial port configuration:
   • Set the Baud to 115200.
   • Select the alarm panel device from the Used by device drop-down list.
   • Optionally you can give a name to this serial port in the Name field.
6. Close this window and click SAVE.
7. After Luup has restarted reload the UI.
8. Enjoy using the plugin. :)